How to paste the protective film of 3DS?

1. Clean the surface of the 3D S with a wipe cloth, and pay attention not to exert too much, so as not to make the 3D S fancy.

2. Tear off the white paper protruding from the left side of the film, gently stick it up at the four corners of the picture below, press the anti-displacement sticker on the left side, then pull the transparent sticker down with your finger at the middle position (floating 2-3 mm), then gently press the protective film on the picture below with your finger, and finally open the upper right corner. The stickers are finished!

3. The method of the upper picture and the lower picture is basically the same, but we should pay attention to the position of the camera and the microphone in the inside before pasting, and do not leave any space on the edge.

4. If you accidentally walk into the bubble when posting, you can use the attached small metal card to gently scrape out the bubble.